Lenze EMF2173IB User Manual

3 Electrical installation
EDK2173DB DE/EN/FR 5.1
20
l
H1_E_INST−2177_Beleg_Sub−D
3 Electrical installation
Establishing the connection between PC/notebook and 9400 servo drives ( 7 )
(see fold−out page)
1. Connect a Sub−D plug (e. g. type EWZ0046 by Lenze) to a cable specified by the CiA
organisation (CAN in automation).
2. For the connection between the controller and the system bus adapter, attach this
Sub−D plug to the connection of the controller.
3. Connect the Sub−D plug contained in the scope of supply to the other end of the
cable.
4. Establish the connection to the system bus adapter.
Establishing the connection between PC/notebook and other controllers ( 8 − ; )
(see fold−out page)
1. Attach the 2173 PC system bus adapter 2 to the parallel interface of the
PC/notebook.
2. Connect the PS2/DIN keyboard connector 3 of the PC/notebook to the voltage
adapter0.
3. Plug the voltage adapter 0 into the keyboard input of the PC/notebook 4.
4. Connect the 3−pole cable that is connected to the Sub−D plug with the plug 6 for the
device to be connected according to the imprinted labelling (for selection see
illustration).
5. Insert the plug in the socket of the device to be connected, which is provided for this
purpose.
6. Plug Sub−D plug 5 into the PC system bus adapter.

Lenze EMF2173IB Specifications

General

Brand	Lenze
Model	EMF2173IB
Category	Adapter
Language	English