8
USING YOUR 2IN1 HUMIDIFIER & DIFFUSER
Note:
• If there is no water in the tank, the
humidifier will not turn on and will
blink. Fill the water tank (see Getting
Started, page 6).
• Keep the humidifier stable while using, or
water may spill.
• Do not block the mist outlet. This will
damage the humidifier. [Figure 2.1]
1. Press once. The humidifier will start
on the low mist level. [Figure 2.2]
2. Press repeatedly to cycle through
mist levels (low, medium, high) and to
turn the humidifier o. [Figure 2.2]
Mist Level
Intelligent Sleep Mode turns o all display
lights and uses a humidity sensor to
automatically adjust the mist level to
maintain a 60% relative humidity (RH) while
you sleep.
1. Press to turn on the humidifier.
Intelligent Sleep Mode
Note: The humidifier must be on to start
Sleep Mode.
2. Press to start Sleep Mode. After 5
seconds, all display lights will turn o.
3. Press a second time (or press )
to cancel Sleep Mode. The humidifier
will go back to the previously set mist
level.
Note:
• Excessive humidity can cause health
issues and mold growth. If the relative
humidity in your room is over 60%,
use the low mist setting or turn o
the humidifier.
Do not block
Figure 2.1
Figure 2.2
Low
Medium
High