7
3. Place the filters back into the air purifier.
The Pre-Filter must be facing outward
and the Activated Carbon Filter must
be facing inward for both filters. Make
sure the pull tabs are visible and facing
inward. [Figure 1.3]
4. Replace the filter cover. Twist the cover
lock counter-clockwise to secure the
cover.
5. Place your air purifier on a flat, stable
surface with the air outlet facing up.
Leave 15 inches / 38 cm of clearance on
all sides of the air purifier.
6. Connect the AC power adapter to the
air purifier. Plug into an outlet.
Figure 1.3
USING YOUR AIR
PURIFIER
1. Press the Control Button to turn on the
air purifier. The fan will start on “SLEEP”.
2. Optionally, press the Control Button
repeatedly to change fan speed
(“SLEEP”, “LOW”, and “HIGH”), and to
turn the air purifier o.
WARNING: Make sure the air outlet and the
air inlets are not blocked. This may cause
the air purifier to overheat and stop working.
Note:
• Sleep Mode uses the lowest
possible fan speed for a quiet
environment.
• In Sleep Mode, the display lights
will automatically turn o after 5
seconds. Press the Control Button
again to turn the display lights back
on for 5 seconds.
Note:
• “HIGH” is the loudest fan speed, but
cleans air the quickest.
• For best results, or to address
a specific air quality issue such
as smoke, run the air purifier on
“HIGH” for 15–20 minutes before
using a lower speed.
• To eectively clean air, keep
windows and doors closed while
the air purifier is on.
GETTING STARTED CONT.
Pull tabs facing inward
To Next Page
Loading...
Need help?
General
