To Next Page

To Previous Page

ENG

ENGLISH

ASSEMBLING AND PREPARING

Using the Kensington locking

device

The connector for the Kensington lock is located

on the rear of the monitor.

For more information on installation and usage,

refer to the Kensington lock user manual or visit

the website at http://www.kensington.com.

Connect the monitor to the table with the Kensing-

ton lock cable.

Using the Kensington lock is optional. The

accessories can be purchased at your local

electronics store.

NOTE

Once the pin is removed, it is not necessary

to re-insert it to adjust the height.

Adjusting the stand height

Place the monitor mounted on the stand base

in an upright position.

Remove the

tape

attached at the bottom rear

of the

stand body,

then pull out the

locking

The height can be adjusted up to

110 mm

Do not put your finger be-

tween the screen and the

base (chassis) when adjust-

ing the screen's height.

Tape

Locking Pin

Stand Body

CAUTION

WARNING

110.0mm

LG 22MP55PJ User Manual

Questions and Answers: