10
ENG
ENGLISH
ASSEMBLING AND PREPARING
1
Please remove the cable installed to the monitor.
2
Please put a soft cloth on a low table or box to
protect the screen of the monitor.
Please put the monitor on the soft cloth with
the screen facing down.
3
Please use the driver(-) or coin insert thumb
screw and turn left arrow direction unlock.
Please pull the Stand Base in the direction of
the arrow as shown below and disassemble
as shown below.
4
After fixing the monitor in one hand, remove the
Stand body by pulling it strongly in the direction
of the arrow as shown below.
1
2
1
2
*
If it is difficult to remove, you can push the
Latch with a small flat-head screw driver or a
flat-headed tool and disassemble as shown
below.
Detaching the Stand Base
To Next Page
Loading...
Need help?
General
