ENGENGLISH
17
Troubleshooting
Cannot control the TV with the remote control.
y Check the remote control sensor on the product and try again.
y Check if there is any obstacle between the product and the remote
control.
y Check if the batteries are still working and properly installed
( to , to ).
No image display and no sound is produced.
y Check if the product is turned on.
y Check if the power cord is connected to a wall outlet.
y Check if there is a problem in the wall outlet by connecting other
products.
The TV turns o suddenly.
y Check the power control settings. The power supply may be
interrupted.
y Check if the Auto Power Off (Depending on model) /
Sleep Timer / Timer Power Off feature is activated in the
Timers settings.
y If there is no signal while the TV is on, the TV will turn o auto-
matically after 15 minutes of inactivity.
When connecting to the PC (HDMI), 'No Signal', 'Check signal
cable' or ‘Unsupported Format’ is displayed.
y Turn the TV o/on using the remote control.
y Reconnect the HDMI cable.
y Restart the PC with the TV on.
If TV is turned o automatically.
y If Timer Power On is enabled, the TV will be turned on at the
specied time. If you do not operate the TV for two hours, the TV
will be turned o automatically.
y To disable this function, use your remote control to go to
(Settings) Timers Timer Power On 2 Hours Auto
Power Off O.
Maintenance
Cleaning your TV
Clean your TV regularly to keep the best performance and to extend
the product lifespan.
y Make sure to turn the power o and disconnect the power cord
and all other cables rst.
y When the TV is left unattended and unused for a long time, dis-
connect the power cord from the wall outlet to prevent possible
damage from lightning or power surges.
Screen, frame, cabinet and stand
To remove dust or light dirt, wipe the surface with a dry, clean, and
soft cloth.
To remove major dirt, wipe the surface with a soft cloth dampened
in clean water or a diluted mild detergent. Then wipe immediately
with a dry cloth.
y Avoid touching the screen at all times, as this may result in dam-
age to the screen.
y Do not push, rub, or hit the screen surface with your ngernail or a
sharp object, as this may result in scratches and image distortions.
y Do not use any chemicals as this may damage the product.
y Do not spray liquid onto the surface. If water enters the TV, it may
result in re, electric shock, or malfunction.
Power cord
Remove the accumulated dust or dirt on the power cord regularly.
Preventing “Image burn” or “Burn-
in” on your TV screen
y If a xed image displays on the TV screen for a long period of time,
it will be imprinted and become a permanent disgurement on
the screen. This is “image burn” or “burn-in” and not covered by
the warranty.
y If the aspect ratio of the TV is set to 4:3 for a long period of time,
image burn may occur on the letterboxed area of the screen.
y Avoid displaying a xed image on the TV screen for a long period
of time (2 or more hours for LCD) to prevent image burn.
To Next Page
Loading...
Need help?
General
