ENGLISH_index
64
93. [Power Indicator] (Command: f o)
Sets the Power Indicator Settings.
Transmission
(f)(o)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(o)( )(Set ID)( )(OK/NG)(Data)(x)
* This may not be supported on some models.
94. [OSD Display] (Command: k l)
Selects the desired OSD Display option.
Transmission
(k)(l)( )(Set ID)( )(Data)(Cr)
Data 00: No (Off)
01: Yes (On)
Acknowledgement
(l)( )(Set ID)( )(OK/NG)(Data)(x)
* This feature may not be supported for certain models.
95. [Semi-Transparent Brightness] (Command: s n, 95)
Controls semi-transparent mode LED brightness.
Transmission
(s)(n)( )(Set ID)( )(9)(5)( )(Data)(Cr)
Data 00~64: LED brightness 0 to 100
Acknowledgement
(n)( )(Set ID)( )(OK/NG)(9)(5)(Data)(x)
* This feature may not be supported for some models.
96. [Hybrid Mode] (Command: s n, 96)
Sets display’s transparency mode.
Transmission
(s)(n)( )(Set ID)( )(9)(6)( )(Data)(Cr)
Data 00: Hybrid (effect: Off)
01: Hybrid (effect: Full white)
02: Semi-Transparent
Acknowledgement
(n)( )(Set ID)( )(OK/NG)(9)(6)(Data)(x)
* This feature may not be supported for some models.
97. [Return Interval] (Command: s n, 97)
Controls length of time transparent mode is maintained.
Transmission
(s)(n)( )(Set ID)( )(9)(7)( )(Data)(Cr)
Data 00~0a: Time maintained 0 to 10
Acknowledgement
(n)( )(Set ID)( )(OK/NG)(9)(7)(Data)(x)
* This feature may not be supported for some models.
98. [Proximity Sensitivity] (Command: s n, 98)
Sets proximity sensor sensitivity.
Transmission
(s)(n)( )(Set ID)( )(9)(8)( )(Data)(Cr)
Data 00: High
01: Mid
02: Low
Acknowledgement
(n)( )(Set ID)( )(OK/NG)(9)(8)(Data)(x)
* This feature may not be supported for some models.
To Next Page
Loading...
Need help?
General
