HOWTO USE
CONTROL PANEL FEATURES
Following are instructions for starting and using your new dryer. Please refer to specific sections
of this manual for more detailed information, important Warning: To reduce the risk of fire,
electric shock, or injury to persons, read this entire manual, including the important Safety
instructions, before operating this dryer.
[] DLE2150W/DLE2150R/DLE2150S/DLE2150L
DLG2151W/DLG2151R/DLG2151S/DLG2151L
DLE2050W/DLE2050R/DLE2050S/DLE2050L
DLG2051W/DLG2051R/DLG2051S/DLG2051L
O
[] DLE2020W/DLE2020R/DLE2020S/DLE2020L
DLG2021CW/DLG2021CR/DLG2021CS/
DLG2021CL
O
O
O
O
26
POWER ON/OFF BUTTON
Press to turn the dryer ON. Press again to
turn the dryer OFR
NOTE: Pressing the ON/OFF button during
a cycle will cancel that cycle and any load
settings will be lost.
CYCLE SELECTOR KNOB
Turn this knob to select the desired cycle.
Once the desired cycle has been selected,
the standard presets will be shown in the
display. On MANUAL DRY cycles, these
settings can be adjusted using the cycle
settings buttons anytime before starting
the cycle.
START/PAUSE BUTTON
Press this button to START the selected
cycle. If the dryer is running, use this button
to PAUSE the cycle without losing the
current settings.
NOTE: If you do not press the START/PAUSE
button to resume a cycle within 4 minutes,
the dryer automatically turns off.
O
O
O
O
CYCLE SETTING BUTTONS
Use these buttons to adjust the desired cycle
settings for the selected cycle.
TIME AND STATUS DISPLAY
The display shows the settings, estimated
time remaining, options, and status messages
for your dryer.
OPTION BUTTONS
The option buttons allow you to select
additional cycle options. Certain buttons
also allow you to activate special functions
by pressing and holding the button for
3 seconds.
For detailed information about the individual
options, please see the following pages.
MORE TIME/LESS TIME BUTTONS
Use these buttons with MANUAL DRY and
TIME DRY cycles to adjust the drying time.
Press the MORE TIME button to increase
the selected manual cycle time by a minute;
press LESS TIME to decrease the cycle time
by a minute.
To Next Page
Loading...
Need help?
General
