HOW TO USE
Custom program
If you have a special combination of settings that you use
frequently, you can save these settings as a CUSTOM PROGRAM.
To Save a Custom Program:
desired cycle.
cycle.
3. Press the cycle option button(s) for the option you would like to
add. A confirmation message will be shown in the display.
4. Press and hold the CUSTOM PROGRAM button for 3 seconds.
You may save only one custom program at a time. Pressing
and holding the CUSTOM PROGRAM button will overwrite any
previously saved custom program.
To Recall a Custom Program:
3. Press the START/PAUSE button to start the cycle.
Steam functions
To Fill the Steam Feeder
3. Fill the steam feeder just to the filter screen.
4. Place the steam feeder in the drawer; then push in the drawer
until it clicks into place.
water up to the MAX line. If not, the error will be displayed.
If you see the error, make sure that the steam feeder is filled with
water and the drawer is fully closed. Turn the dryer off then restart
the Steam Cycle.
substances, rinse agents, or detergents.
generator will not work.
overflow.
drawer before starting the dryer.
w
WARNING
Failure to follow this warning can cause serious
injury or death.
Failure to follow
this warning can cause serious injury or death.
Water
ONLY
Steam
Feeder
NOTE
NOTE