5
UNDERSTANDING YOUR MICROWAVE OVEN
SPECIFICATIONS
*IEC 60705 RATING STANDARD
Specifications subject to change without prior notice.
MODEL
LCS1410SW
Power Supply
Rated Power Consumption
Microwave Output
Frequency
Rated Current
Overall Dimensions(WxHxD)
Oven Cavity Dimensions(WxHxD)
Effective Capacity of Oven Cavity
120 V AC, 60 Hz
1650 W
*1200 W
2450 MHz
13.8 A
21
7
/8"x12
1
/2"x16
5
/16"
15
11
/16"x10
3
/32"x15
5
/8"
1.4 Cu.ft.
INSTALLATION
A. Circuits
For safety purposes this oven must be plugged into a
20 Amp circuit. No other electrical appliances or light-
ing circuits should be on this line. If in doubt, consult a
licensed electrician.
B. Voltage Warning
The voltage used at the wall receptacle must be the
same as specified on the oven name plate located on
the back or on the side of the control panel of the oven.
Use of a higher voltage is dangerous and may result in
a fire or other type of accident causing oven damage.
Low voltage will cause slow cooking. In case your
microwave oven does not perform normally in spite of
proper voltage, remove and reinsert the plug.
C. Placement of the Oven
Your microwave oven can be placed easily in your
kitchen, family room, or anywhere else in your home.
Place the oven on a flat surface such as a kitchen
countertop or a specially designed microwave oven
cart at least 100cm (39.4 inches) from floo r. Do not
place oven above a gas range. Free air flow around
the oven is important. Allow at least 4 inches
of space at the top, sides, and back of the oven for
proper ventilation.
NOTES:
• Never place the turntable in the oven upside down.
D. Do not block the air vents
All air vents should be kept clear during cooking. If air
vents are covered during oven operation the oven may
overheat. In this case, a sensitive thermal safety device
automatically turns the oven off. The oven will be
inoperable until it has cooled suf ficiently.
E. Radio interference
1. Microwave oven operation may interfere with TV
or radio reception.
2. When there is interference, it may be reduced or
eliminated by taking the following measures:
a. Clean the door and the sealing surfaces of the
oven.
b. Reorient the receiving antenna of radio or TV.
c. Relocate the microwave oven in relation to the
TV or radio.
d. Move the microwave oven away from the
receiver.
e. Plug the microwave oven into a dif ferent outlet
so that microwave oven and receiver are on
different branch circuits.
To Next Page
Loading...
Need help?
General
