35OPERATION
ENGLISH
Raising the Rack
Lift the rack at the center of each side until the rack
locks into place in the upper position. It is not
necessary to lift the lock levers to raise the rack.
Removing the Snap-In Gliding
Upper Rack
This feature is only available on some models.
These instructions are for models with snap-in rack
supports rather than wheeled rack supports.
• The snap-in upper rack should only be removed
for servicing. If you need to remove the rack,
wear gloves and handle the screwdriver carefully
to avoid personal injury or damage to the
dishwasher.
1 Pull the upper rack out until it stops. Remove
any contents from the rack.
2 To remove the front rack supports from the
rails, push the front hooks open with a flat-
blade screwdriver while pulling the front of
the rack up to snap the front rack support out
of the hooks. Repeat to snap the front support
out on the opposite side.
3 To remove the back rack supports from the
rails, hold a side rail with one hand, lift the
front of the rack, and firmly push the rack
back to snap the support out of the hooks in
the rear. Repeat on the opposite side.
4 To replace the rack, place the back rack
supports behind the rear hooks and pull the
rack forward to snap the supports into the
hooks. Then align the front rack supports with
the front hooks and push the front of the rack
down to snap the supports into the front
hooks.
Loading the Cutlery Rack
The cutlery rack is best suited for flatware. The
separators on the cutlery racks help keep flatware
separated to avoid damage and improve cleaning.
• For best cleaning performance, place flatware in
the silverware baskets. Heavily soiled utensils or
items with baked on foods should be placed in
the middle rack or spoon basket for best
performance.
Loading Silverware into the Cutlery
Rack
This feature is only available on some models.
us_main.book.book Page 35 Wednesday, June 29, 2022 8:57 AM
To Next Page
Loading...
Need help?
General
