ENGLISH
DOOR ALIGNMENT
19
LEVELING THE REFRIGERATOR DOORS (CONT.)
STARTING
Before loading your refrigerator with fresh foods:
• Remove tape and any temporary labels from
your refrigerator before using. To remove any
remaining adhesive residue, rub the area briskly
with your thumb, or rub a small amount of liquid
dish soap over the adhesive with your fingers.
Wipe with warm water and dry. Do not use sharp
instruments, rubbing alcohol, flammable fluids,
or abrasive cleaners to remove tape or glue.
NOTE: Do not remove any warning-type labels,
the model and serial number label, or the tech
sheet that is taped to the back of the refrigerator.
• Thoroughly clean your refrigerator and wipe off all
dust that may have accumulated during shipping.
• Install accessories such as the ice cube bin,
drawers, and shelves, in their proper places.
They are packed together to prevent possible
damage during shipment.
• Adjust the desired temperature for the
refrigerator and freezer (see Adjusting the
Temperature and Functions).
• Let your refrigerator run for at least 2 or 3 hours
before putting food in it. Check the flow of cold
air in the freezer compartment to ensure proper
cooling. Your refrigerator is now ready for use.
If the space between your doors is uneven, follow
the instructions below to align the doors:
• With one hand, lift up the door you want to raise
at middle hinge.
• With other hand, use pliers to insert snap ring as
shown.
• Insert additional snap rings until the doors are
aligned.
(Three snap rings are provided with unit.)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
