3-11
Copyright © LG Electronics Inc. All rights reserved.
Only training and service purposes
COMPONENT ACCESS
1. Turn off the electrical supply and gas supply going
to the range.
2. Remove the back cover (see “Removing the Back
cover” Page 3-2).
3. Remove the igniter connector and 1 screw from
air shutter.
4. Remove the door.
5. Remove 9 screws from the fan cover.
6. Remove 5 screw from the burner assembly cover.
7. Remove 3 screws to disassemble convection
burner and igniter.
REMOVING THE CONVECTION BURNER ASSEMBLY
WARNING
• DISCONNECT power supply cord
from the outlet before servicing.
• Replace all panels and parts before
operating.
•
RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electrical shock.
•
Make sure the igniter connecter is
completely outside when reinstalling
the broil burner assembly.
CAUTION
• Be careful when you work on the
gas range handling the sheet metal
part.
- Sharp edge may be present and you can cut
yourself.