- 9 -
1. Safety Precautions
1. It is safe to adjust after using insulating transformer between
the power supply line and chassis input to prevent the risk of
electric shock and protect the instrument.
2. Never disconnect leads while the TV receiver is on.
3. Don't short any portion of circuits while power is on.
4. The adjustment must be done by the correct appliances.
5. Unless otherwise noted, set the line voltage to 230Vac
!10%,
50Hz.
6. The adjustment of TVshould be performed after warming up
for 15 minutes.
2. Test Equipment required
1. RF signal generator (with pattern generator)
2. DC Power Supply
3. Multimeter (volt meter)
4. Oscilloscope
5. Color analyzer
3.
DVCO
Adjustment
1) This is for adjustment of VCT38XX,crystal oscillator
frequency after receiving a company Digital
pattern.(PAL:EU05CH,NTSC:13CH)
2) When entering adjustment mode by pressing IN-START
button,DVCO adjustment is operating automatically.
(T/X doesnÕt operating occassionally during DVCO
adjustment.)
4. Focus Adjustment
4-1. Preparation for Adjustment
Tune the TV set to receive a digital pattern.
4-2. Adjustment Method
1) Single Focus CPT
Adjust the upper Focus volume of FBT for the best focus of
horizontal line A,vertical line B.
2) Double Focus CPT
1) Adjust the lower Focus volume of FBT for the best focus of
vertical line B.
2) Adjust the upper Focus volume of FBT for the best focus of
area A.
3) Repeat above step 1) and 2) for the best overall focus.
5.
Screen Voltage & White Balance Adjustment
5-1. Adjustment of screen manually
(Using ADJ.Remote Control)
1) Receive the PAL or SECAM(NTSC) signal into RF mode
regardless of channel.
2) If you press the ÒADJÓbutton in LINE SVC mode(IN-START
button),the LINE SVC mode changes to screen adjustment
mode.
3) Turn the Sreen Volume of FBT to change luminance of
White signal center as shown below.(Deviation ! 1FL)
4) Press the EXIT button (Like TV/AV) to exit SVC mode.
5-2.
Adjustment of white balance manually(LIne-SVC 1)
1) Tune the TV set to receive an 100% white pattern.
2) Adjust LOW LIght status of CUT R,CUT B at CUT G:50.
3) Adjust HIGH LIght status of WDR R,WDR B at WDR G:380.
4) Repeat above step 2) and 3) for the best condition each
status of High Light and Low Light.
NOTE : When adjusting white balance automatically,connect the
adjustment JIG in SVC mode.(When pressing IN-
START,MUTE button on remote control for adjustment
orderly,it changes to SVC mode and screen displays
SVC.)
Luminance(Manual)
6
!
1FL
8
!
1FL
5
!
1FL
6
!
1FL
8
!
1FL
CPT & INCH
29Ó FLAT
25Ó FLAT
29Ó NORMAL
25Ó NORMAL
28Ó NORMAL
Note
Single Focus
ADJUSTMENT INSTRUCTIONS
To Next Page
Loading...
Need help?
General
