35
PROGRAMMING MODE
13. Beep volume
Entering set up
mode.
You will see LqC1
Button Display
Press the High Temp. button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Display previous value.
Press Med Temp.(+) or Low Temp.(-) button to select High or
Low or O.
Press the Start button.
The machine sets up the beep volume, then advances to the next
process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/o toggle switch.
• Card type - Pull the service card.
• Stack type - 1. Control panel open.
2. Turn on/o toggle switch.
• OPL/Coin Type - Press “High Temp.” twice.
MFL62512875_150414.indd 35 2015.4.14 9:44:0 AM
To Next Page
Loading...
Need help?
General
