31
PROGRAMMING MODE
9. Value of coin 1
Entering set up
mode.
You will see LqC1
Button Display
Press the High Temp. button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Display previous coin 1 value.
Press Med Temp.(+) or Low Temp.(-) button to select value of
coin 1 (The value can be set fronm 0 to 9,90 in 0.1 increments.)
Press the Start button.
The machine sets up the value of coin 1, then advances to the
next process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/o toggle switch.
• Card type - Pull the service card.
• Stack type - 1. Control panel open.
2. Turn on/o toggle switch.
• OPL/Coin Type - Press “High Temp.” twice.
MFL62512875_150414.indd 31 2015.4.14 9:43:56 AM
To Next Page
Loading...
Need help?
General
