To Next Page

To Previous Page

PROGRAMMING MODE

2. Factory reset - EEPt

After a factory reset, all values are reset to the default values.

Entering set up

mode.

You will see LqC1

Button Display

Press the Med Temp. or the Low Temp. Button until

appears in the display.

Press the Start button.

Press the Med Temp. button until appears in the

display.

Press the Start button, then factory reset is done.

is displayed.

1. Continue to set up the next mode.

2. Stop the change of setup value and go back to ready mode.

• Coin type - Turn on/o toggle switch.

• Card type - Pull the service card.

• Stack type - 1. Control panel open.

2. Turn on/o toggle switch.

• OPL/Coin Type - Push “High Temp.” + “Low Temp.” and the ‘3’.

• Dryer default value for CARD/COIN machine.

- Drying time 50 Minute

- Top off time 10 Minute

• Drying time in OPL machine can be changed from 10 to 100 Minutes by pressing the cycle button.

NOTE

MFL62512875_150414.indd 40 2015.4.14 9:44:3 AM

LG RP1329AD1S User Manual

Questions and Answers: