4-5. TEST RUNNING WITHOUT WATER
• To use the CHECK PROGRAM (QC TEST MODE), press WATER LEVEL and POWER button ON without
depositing any laundry.
• In QC TEST MODE all LEDs are on and press START(PAUSE) button to check over the following items.
METI KCEHCYALPSIDDOHTEMKCEHCON
1
2
3
4
5
6
7
8
9
Initial state
Press once
Press twice
Press 3 times
Press 4 times
Press 5 times
Press 6 times
Press 7 times
Press 8 times
• WATER LEVEL frequency is
on DISPLAY in the condition of
no water in TUB.
• After detecting laundry amount
the number of pulse is on the
DISPLAY.
• AUTO OFF
• All LEDS ON.
64~70 DISPLAY.
• Laundry amount test.
• COLD water.
• HOT water. (option)
• If Error of water temperature sensor is
occured is on the display.
• Shower Valve
• If the LID is opened, is on the
DISPLAY. In that case, close the LID.
• DRAIN MOTOR is 1st start.
• DRAIN MOTOR is 2nd start.
• DRAIN PUMP is on.
• All LEDS OFF.
35
To Next Page
Loading...
Need help?
General
