To Next Page

To Previous Page

18 HOW TO USE

TIME AND STATUS DISPLAY

The time and status displayshows the estimated time remaining and cycle progress.

Processing Est.Time Remaing

Sensing_Wash_ Rinse_ Sp n Q

A CYCLE STATUS INDICATOR C

These LEDs will illuminate when a cycle

is selected to indicate which stages will

run. When a cycle is running, the LED for

the active stage will blink, and the LEDs

for the remaining stages will remain

steady. Once a stage is complete, the

LED will turn off. If a cycle is paused, the

active stage LED will stop blinking.

DELAY WASH INDICATOR

The Delay Wash Indicator will illuminate

when a delay wash is set. The indica-

tor light will turn off once the cycle has

started.

ESTIMATED TIME REMAINING

When a cycle is selected, the default

time for that cycle is displayed. This time

will change as modifiers or options are

selected. Once the START/PAUSE but-

ton is pressed, the washer will measure

the size of the load. The estimated time

may change once the load size has been

measured. If Delay Wash is set, the re-

maining delay time counts down until the

cycle begins.

NOTE: The time shown is only an esti-

mate. This time is based on normal oper-

ating conditions. Several external factors

(load size, room temperature, incoming

water temperature, etc.) can affect the

actual time.

LID LOCK INDICATOR

The Lid lock indicator will illuminate once

a cycle has started. The indicator light

will stay on until the cycle is paused,

stopped or has finished.

Questions and Answers:

Need help?

Do you have a question about the LG WT5680HWA and is the answer not in the manual?

LG WT5680HWA Specifications

General