Linear 2GIG-TS1 User Manual

©2013 2GIG Technologies Inc. All Rights Reserved. 3
LEARNING/PAIRING THE KEYPAD WITH THE
CONTROL PANEL
1 MakesurethattheControlPanelhaspowerusingthesuppliedAC
adapterandconfirmthattheadapterisconnected.
WARNING: AControlPanelwithoutthe900MHzTransceiver
installedcannotcommunicatewiththe2GIG‐TS1.
2 Makesurethatthe2GIG‐TS1haspowerfromthesuppliedAC
transformer.ConnecttheACadaptertothe2GIG‐TS1.Confirmthat
thewiresareconnectedusingthecorrectpolarity.
3 Asthe2GIG‐TS1powersup,thefollowingmessageisvisibleonthe
display.
4 FromtheControlPanel’sInstallerToolbox,selectSystem
Configuration.
5 SelecttheGoTobutton.
6 Togotoquestion4,enter04.
7 SelecttheRFKeypadnumbertoassigntothe2GIG‐TS1.Usethe→
arrowtoselecttheRFKeypadnum ber(1‐4).AfterselectingtheRF
Keypadnumber,pressthe↓arrowtostartconfiguringthespecific
parametersfortheRFKeypad.
8 Pressthe→arroworpressthenumber1onthekeypadtogglethe
sengonthefirstquesonto“used”.Pressthe↓arrowtoconnue
configuringoptions.
9 SettheRFKeypadEquipmentCodeto1059bypressingthe→arrow
until“(1059)2GIG‐TS1wirelesstouchscreenkeypad”appears.Press
the↓arrowtoadvancetothenextopon.
10 Learnthe2GIG‐TS1intotheControlPanel.Aerpressingthe↓
arrowinthepreviousstep,theLearnbuttonappears.
INITIATING THE PAIRING PROCESS
InitiatethepairingprocessattheControlPanelbypressingtheLearn
button.

Linear 2GIG-TS1 Specifications

General

Brand	Linear
Model	2GIG-TS1
Category	Keypad
Language	English