35
Chapter 5: Configuring the Router
The Administration Tab - Factory Defaults
EtherFast Cable/DSL Router with 4-Port Switch
The Administration Tab - Factory Defaults
The Factory Defaults screen allows you to restore the Router’s configuration to its factory default settings.
Factory Defaults
Restore Factory Defaults. To clear all of the Router’s settings and reset them to its factory defaults, click the
Yes radio button.
After you have clicked the Yes radio button, click the Save Settings button to restore the Router to its factory
defaults, or click the Cancel Changes button to undo your change. Help information is shown on the right-hand
side of the screen.
Figure 5-28: Administration Tab - Factory Defaults
Note: Do not restore the factory defaults unless you are having difficulties with the Router and have
exhausted all other troubleshooting measures. Once the Router is reset, you will have to re-enter all
of your configuration settings.
To Next Page
Loading...
Need help?
General
