Lippert Components 285318 User Manual

5
lci1.com 574-537-8900 Rev: 03.06.20
Power Tongue Jack
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0001301
Operation
NOTE: The ON and OFF light switch (Fig.6A) controls the
power tongue jack’s light only. If left on for an extended
period of time, the light will drain the trailer’s battery.
NOTE: The power tongue jack is designed for vertical
movement of the trailer only.
Unhitching from Tow Vehicle
1. Chock the tires of the trailer.
2. Make sure the footpad of the power tongue jack is
pinned securely in place with the clevis pin and hairpin
cotter pin (Fig.5B).
3. Make sure the ground surface under the power tongue
jack is rm and level.
4. Push EXT (Fig.6C) to extend the power tongue jack until
the footpad touches the ground and the coupler clears the
hitch ball.
5. Disconnect all electrical and mechanical connections
between the trailer and tow vehicle.
6. Move the tow vehicle away from the trailer.
7. Push RET (Fig.6B) as needed to return the front of the
trailer to level.
Hitching to Tow Vehicle
1. Chock the tires of the trailer.
2. Press EXT (Fig.6C) if needed to allow the coupler to clear
the hitch ball.
3. Push RET (Fig.6B) to retract the power tongue jack until
the coupler properly mounts the hitch ball and the leg of
the power tongue jack is fully retracted.
NOTE: Make sure the leg of the power tongue jack (Fig.5A)
is fully retracted prior to moving the tow vehicle.
Fig.5
Fig.6
A
B
A
B
C

Lippert Components 285318 Specifications

General

Brand	Lippert Components
Model	285318
Category	Jacks
Language	English