12
DAB Operation
If the unit is connected to the mains power and then
switched on from standby for the rst time, the unit will
automatically enter into the DAB mode and perform
auto scan function. During the scan the display will show
“Scanning ...” together with a slide bar that indicates the
progress of the scan and the amount of stations that have
been found so far.
Once the scan has nished, the unit will select the rst
alphanumerically found station. To explore the found
stations, press the TUNE/SELECT button and then turn the
VOLUME/SELECT control. When you nd a station that you
would like to listen to, press the TUNE/SELECT button.
1. To activate auto scan, rst press the MENU button
to enter into the Tune Select Menu, then rotate the
VOLUME/SELECT control to select “Autoscan”, nally
press the SELECT button to conrm, the display will
show “Scanning …” and a progressing slide bar.
2. All the stations that have been found will be stored
automatically, to explore and select listening to the
found stations, press the TUNE/SELECT button and
then turn the VOLUME/SELECT control. Press the
TUNE/SELECT button to conrm.
DAB Auto Scan
The auto scan will search for the entire DAB Band III channels. After the scan has nished, the
rst alphanumerically found station will be automatically selected.
If no stations are found after auto scan, the unit will then enter into the Tune
Select Menu. Turn the VOLUME/SELECT control and then press the TUNE/
SELECT button to select manual tune or auto scan modes for stations.
Full auto scan will not replace the DAB stations in memory. If you want to
remove all the previous scanned stations, system reset is required.
L55DAB10_IB_110810_Zell.indd 12 10/08/2011 10:44 AM
To Next Page
Loading...
Need help?
General
