8
12. Put the top cover back on and x it in
place with the screws.
13. With the doors closed, check that the
doors are aligned horizontally and
vertically and that the seals are closed on
all sides. Re-adjust the levelling feet as
needed.
Before Using Your Unit
Before placing any food in your unit, turn it on and wait for 24 hours, to make sure it is
working properly and to allow it time to fall to the correct temperature. Your unit should not
be overlled.
Cleaning Before Use
Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm
water using a ‘wrung-out’ sponge or cloth. Wipe completely dry before replacing the shelves,
drawers and salad bin. Clean the exterior of the unit with a damp cloth.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the
unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant uid needs time
to settle.
In some cases, the door seal may be crushed after prolonged storing pressure, resulting to
the door seal not able to close properly when reversed.
Follow the steps below to solve the issue:
1. Peel o the door seal from the upper or lower corner
and warm it with a hairdryer; the warmth can allow
the door seal to return to its original form. Do not
blow directly on the unit as the warmth may damage
other parts of the unit.
2. Rotate the door seal upside down so that the side
originally with the hinge stay with the hinge.
3. Insert the door seal back into the door from the
upper or lower corner.
4. If the issue still occurs, contact your local service centre for assistance.
180°
LFFD55S18_IB_RC_200716_grace.indd 8LFFD55S18_IB_RC_200716_grace.indd 8 16/7/2020 8:00 PM16/7/2020 8:00 PM
To Next Page
Loading...
Need help?
General
