7
Using Your Hob
1. Rotate the control to the heat level you wish to use for the selected cooking zone.
LEVEL 0 LEVEL 1 LEVEL 2 LEVEL 3 LEVEL 4 LEVEL 5 LEVEL 6
OFF
Simmering
(Low)
Cooking at
medium temperature
Cooking, frying and boiling
(High)
2. When the hob indicator lamp illuminates above the controls, this means that one or more of the hobs are
switched on.
3. When you are finished cooking rotate the control back to the “0” position, the hob indicator lamp will turn
off. The cooking zones will remain hot for some time and the hot hob warning light will illuminate. Do not
touch the hobs until they have completely cooled down.
Always lift pans off the ceramic hob – do not slide, or they may scratch the glass.
• The heated areas will be seen to switch on and off even when higher heat settings are used. This is
due to a safety device, which prevents the glass from overheating. Some switching on and off when
cooking at high temperatures is quite normal, causes no damage to the hob and little delay in
cooking times. Excessive switching may however be caused by the use of an unsuitable cookware
or a saucepan which is smaller than the heated area. If excessive switching occurs, discontinue the
use of the cookware.
• To improve performance, and reduce energy, always use pans with close fitting lids.
• If the ceramic hob glass surface is cracked, switch of the appliance to avoid the possibility of
electric shock.
LFSTC50W_IB_110420.indd 7 20/04/2011 3:48 PM
To Next Page
Loading...
Need help?
General
