18
Setting the Child Lock
The Child Lock prevents children from stopping or changing programmes accidentally. It locks
all buttons and the programme dial. If the Child Lock is activated you won’t be able to switch the
dryer o using the Programme Dial. To switch the dryer o you will need to switch it o at the
mains socket.
1. Make sure the dryer is plugged into the mains.
2. Select your desired programme and start the drying cycle.
3. During a drying programme, press the Delicate and Anti-crease buttons at the same time for
3 seconds or more to activate the Child Lock function. The machine will beep and the Delicate
indicator will ash briey.
When the child lock is activated, if you turn the Programme Dial or press any buttons the dryer
will beep and the Delicate indicator will ash to indicate your Child lock is active.
The Child lock will not deactivate automatically at the end of a programme.
Switching the Child Lock o
Switch the child lock o by turning the Programme Dial to OFF then back to the programme the
child lock was set on. Then press the Delicate and Anti-crease buttons at the same time for 3
seconds or more. The machine will beep and the Delicate indicator will ash briey.
Emptying the Water Tank
You must empty the water tank after every drying cycle.
1. Pull the water tank out of the slot
using the handle. When the tank is
approximately half way out you will
need to use your other hand to hold
the tank. Remember its full of water
and will be quite heavy.
• Never operate the dryer without the
water tank inserted into the dryer.
2. Pour the water into a sink or drain.
3. When empty replace the water tank.
Make sure you push it all the way in.
Logik 8 kgs Heat Pump Tumble Dryer LHP8W22 Manual.indd 18Logik 8 kgs Heat Pump Tumble Dryer LHP8W22 Manual.indd 18 26/09/2022 15:1726/09/2022 15:17
To Next Page
Loading...
Need help?
General
