Levelling the Unit
To do this adjust the two levelling feet at the front of the
unit.
If the unit is not level, the door and magnetic seal
alignments will not be covered properly.
Cleaning Before Use
Wipe the inside of the unit with a weak solution of warm water and bicarbonate soda. Then
rinse with warm water using a ‘wrung-out’ sponge or cloth. Wash the shelves and trays with
a mild detergent solution. Wipe completely dry before replacing the shelves and bottle rack.
Clean the exterior of the unit with a damp cloth, using mild detergent and warm water.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the
unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs time
to settle.
Before Using Your Unit
Before placing any wine in the unit, turn it on and wait for 24 hours, to make sure it is
working properly and to allow it time to fall to the correct temperature. Your unit should not
be overfilled.
9
LWC59B12_IB_Running Change_120822_Edits_Pauline.indd 9 22/08/2012 11:59 AM
To Next Page
Loading...
Need help?
General