Logitech QuickCam Express Getting Started

2
Installing Your Camera
3 Ins talling Your Camera
N ote Your computer must be running Microsoft
®
W indows
®
98 or W indows
®
95
4.00.950B or C (or later). To check your version of Windows 95,
• Right-click the “My Computer” icon on the Windows desktop.
• Click Properties.
• Verify that you have “System: Microsoft
®
W indows 95 4.00.950B or C”.
1 . Install the software first! Insert the QuickCam Express software CD into
your
computer’s CD-ROM drive.
2. If the Setup screen does not display,
• Go to the Taskbar and click Start, then Run.
• Type D:\SETUP.EXE and press the Enter key, where D: is the drive designation
of
your CD-ROM drive.
3. Follow the on-screen instructions.
4. Assemble the camera.
After you reboot your system
toward the end of software
installation, Setup will prompt
you to connect the camera cable
to your computer:
• Remove the camera and
its
base from the packaging.
• Mount the camera on its base.
• Remove the protective cap
from the end of the camera
cable.
• Insert the camera cable into your computer’s USB port.
• Continue with software installation by following the on-screen prompts.
USB connector

Logitech QuickCam Express Specifications

General

Brand	Logitech
Model	QuickCam Express
Category	Webcam
Language	English