Doc: I470GB10_16.docx 18/10/2016 p. 1 / 19
RGK400SA RGK420SA
STAND-ALONE GENERATING SET CONTROLLERS
INSTRUCTION MANUAL
● The manufacturer cannot be held responsible for electrical safety in case of improper use of the equipment.
● The products illustrated herein are subject to alteration and changes without prior notice. Descriptions and specifications are therefore not contractually binding.
● A circuit breaker must be included in the electrical installation of the building. This must be installed near the equipment and within easy of the operator. It must be marked
as the disconnecting device of the equipment: IEC/ EN 61010-1 § 6.12.2.1.
● Clean the equipment with a soft cloth; do not use abrasive products, liquid detergents or solvents.
Contents
Page
Functions of front panel buttons and controls
Navigating between the display pages
Switching on and starting up (RGK400SA)
Switching on and starting up (RGK420SA)
Parameter setting from PC
Parameter setting from smartphone or tablet via Wi-Fi
Parameter setting from smartphone or tablet via NFC
utomatic acquisition of rpm/W ratio
Parameter settings (setup) from front panel
Programmable input functions
Programmable output functions
Mechanical dimensions and panel cut-out
Technical characteristics
CAUTION!
● Read this manual before use and installation.
● This equipment must be installed by qualified personnel according to applicable standards in order to prevent injury or damage to property.
● Before any maintenance operation on the device, disconnect power from all measuring and power supply inputs.
To Next Page
Need help?
General
