16
LOADER REMOVAL
CAUTION: Never park loader
without bucket attached to
the loader.
CAUTION: Never allow
weight of tractor to be put on
parking leg when removing
loader.
NOTE: Driving the tractor forward slowly
while positioning loader will allow
parking stands to contact ground firmly.
Using float position during this operation
will keep tractor weight from being
applied to loader parking stands.
STEP 1. Position loader on hard level
surface. Raise boom. Put bucket in dump
position. Lower the loader until front edge of
bucket is on the ground and shut tractor off.
STEP 2. Remove parking leg from stored
position and put it in the park position.
Secure using pin and keeper.
Parking Leg Location
STEP 3. Raise loader and fully retract
bucket. Lower the loader until the parking
leg makes contact on the ground. Tip the
bucket until the bucket cutting edge just
touches the ground.
16 Series, Model - 2816
To Next Page
Loading...
Need help?
General
