35 Series-HST, Model - 3535, 4035, 4535 & 5035
37
Switches
PTO Operation Switches
PTO can be operated by using a combination of "PTO
ON/OFF Switch" and "PTO Mode Switch".
To start the PTO, start engine first, choose "AUTO MODE" or
"MANUAL MODE".
Then press the PTO ON/OFF switch to start the PTO.
PTO MODE switch (PTO Auto / Manual / Off Switch)
This rotary switch enables the operator to choose the AUTO
or Manual mode of PTO and even turn-off the PTO when
desired.
The Operating positions of knob are as follows:
1. Alignment of OFF - Mark with Pointer - PTO Turn-OFF
The Auto and Manual Mode switch will be activated when
the “PTO Engage - Disengage Switch” is in ON position.
2. Alignment of Auto-mark with pointer - Operates
AUTO mode
This switch can be used when the "PTO Engage - Disengage
Switch" is in ON position.
When this switch is in AUTO-POSITION, the PTO shaft
rotation will be stopped as soon as the implement is raised.
While this switch is in AUTO-POSITION, if the PC lever is
lowered, the PTO shaft will become operative and will be
indicated by a CONTINUOUSLY-GLOWING "PTO Engage -
Disengage Switch".
PTO ON/OFF Switch
This is a 2 in 1 switch, located on LH side of steering
column on the dashboard.
1. Press the PTO switch to engage the PTO.
2. To disengage the PTO, press the PTO switch again.
Tampered electrical wiring or connections will
render this feature INEFFECTIVE. In such a case,
some Inadvertent movement of personnel near
the PTO shaft can prove fatal.
To Next Page
Loading...
Need help?
General