MAINTENANCE
CAUTION
:
Always be sure that the tool
is
switched
off
and unplugged before attempting to perform
inspection or maintenance.
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear down
to
the limit mark. Keep the carbon brushes
clean and free to slip in the holders. Both
carbon brushes should be replaced
at
the
same time. Use only identical carbon
brushes.
If
ohter type
of
carbon brushes are em-
ployed in tools equipped with an electric
brake, the electric brake may not operate
properly.
/
Limit mark
Use
a
screwdriver to remove the brush
1
holder caps. Take out the worn carbon
brushes, insert the new ones and secure the
brush holder caps.
Brush holder
cap
71
I
I
Screwdriver
To
maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
To Next Page
Loading...
Need help?
General
