Trimmer guide (Optional accessory)
Trimming, curved cuts in veneers for fur-
niture and the like can be done easily with
the trimmer guide. The guide roller rides
the curve and assures
a
fine cut.
Install the trimmer guide on the guide
holder with the wing bolt
(6).
Tighten the
wing bolt
(B)
only tight enough to hold the
trimmer guide temporarily. Then insert the
guide holder into the holes
in
the tool base
and tighten the wing bolts (A). Adjust the
distance between the bit and the trimmer
guide by turning the fine adjusting screw
(1.5
mm or about
1/16"
per turn). At the
desired diestance, tighten the wing bolt
(6)
to secure the trimmer guide in place. When
adjusting the guide roller up on down,
loosen
the
wing bolt
(C).
After adjusting
it,
tighten the wing bolt
(C)
securely.
When cutting,
move
the tool with the guide
roller riding the side
of
the workpiece.
Wing
bolt
(C)
I
\
Guide
roller
4
Guide
roller
8
To Next Page
Loading...
Need help?
General
