10
Removing built-in battery
CAUTION:
• Never remove the built-in battery from the tool except
when disposing of the tool. The battery will be damaged
or a battery short-circuit could result.
To remove the cover, push it in the direction of the arrow
while pressing down on the “OPEN” portion of the cover.
Withdraw the built-in battery halfway. Disconnect the two
lead wires from the battery by pulling them from the battery
terminals. Then withdraw the battery completely.
To prevent a battery short-circuit, tape the battery terminals
or put the battery into a plastics bag. (Note: Never put two or
more batteries into one plastics bag. Battery short-circuit
may result.)
CAUTION:
• Never incinerate the battery even if it is severely
damaged or is completely worn out. It can explode in a
fire or toxic materials can leak out of it.
EN0001-1
Recycling the Battery
The only way to dispose of a Makita battery is to recycle it.
The law prohibits any other method of disposal.
To recycle the battery:
1. Remove the battery from the tool.
2. a) Take the battery to your nearest Makita Factory Ser-
vice Center
or
b) Take the battery to your nearest Makita Authorized
Service Center or Distributor that has been desig-
nated as a Makita battery recycling location.
Call your nearest Makita Service Center or Distributor to
determine the location that provides Makita battery recycling.
See your local Yellow Pages under “Tools-Electric”.
1. Cover
1
002144
1. Battery terminal
2. Lead wire
3. Battery
1
2
3
002145
Ni-Cd
To Next Page
Loading...
Need help?
General
