7
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off before
adjusting or checking function on the tool.
Charging
Connect the charging plug to the charging connector, then
plug in the charger to the power receptacle. Charging takes 3
hours.
CAUTION:
• The battery in your new tool is not fully charged. You will
need to charge it before use.
• Do not operate the tool during charging.
• Overcharging more than 2 days considerably shortens
the battery service life.
Always unplug the charger after completing the charge.
Switch action
To start the tool, simply pull the switch trigger. Release the
switch trigger to stop.
Reversing switch action
This tool has a reversing switch to change the direction of
rotation. Slide the reversing switch to the right (appear “F”
marking) for clockwise rotation or to the left (appear “R”
marking) for counterclockwise rotation.
CAUTION:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the tool comes to a
complete stop. Changing the direction of rotation before
the tool stops may damage the tool.
1. Charging plug
1
002059
1. Switch trigger
1
002072
1. Reversing switch
1
002085
To Next Page
Loading...
Need help?
General
