Makita 9404 User Manual

10
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding these
accessories, ask your local Makita service center.
• Abrasive belts
• Sanding shoe
• Dust bag
1. Limit mark
1
001145
1. Brush holder cap
2. Screwdriver
1
2
003396

Makita 9404 Specifications

General

Power	1010 W
Uncertainty K	1.5 m/s²
Dust container type	Dust bag
Type of sander	Belt sander
Dust extraction port	Yes
Power source	AC
AC input voltage	230 V

Weight and Dimensions

Depth	143 mm
Width	334 mm
Height	157 mm
Weight	4800 g