Makita BO4565 User Manual

4
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
FUNCTIONAL DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Switch action
1
008302
CAUTION:
• Before plugging in the tool, always check to see
that the tool is switched off.
To start the tool, press the " I " side of the switch. To stop
the tool, press the " O " side of the switch.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing abrasive paper
NOTE:
Use Makita hook-and-loop sandpaper with this sander.
To attach the sandpaper:
2
1
008304
1
2
1
008305
1
2
008306
1. Set the tool upside down so that the pad is on top.
2. Position the sandpaper to fit the shape of the base.
Be sure to align the holes on the sandpaper with
the holes on the pad (the dust will be sucked into
these holes; it is therefore important to leave them
open).
3. Press the paper firmly over the pad.
To remove the sandpaper:
1. Set the tool upside down so that the sandpaper is
on top.
2. Grasping one corner of the sandpaper, peel it
from the pad.
NOTE:
• If the sandpaper is in good condition, save it for
further use.
When sanding in narrow, hard-to-reach areas (e.g.,
shutters, blinds, louvers), attach the cone-shaped
abrasive papers to the end of the pad (bottom and top).
To sand the end of thin materials, fold the abrasive paper
and attach to the side of the pad as shown in the figures.
Dust bag (accessory)
1
008301
1. Dust bag
1. Base
2. Velcro
sandpaper
1. Velcro
sandpaper
2. Base
1. Velcro
sandpaper
2. Base
1. Switch

Makita BO4565 Specifications

General

Power	200 W
Dust container type	Dust bag
Type of sander	Orbital sander
Dust extraction port	Yes
Cable length	2 m
Power source	AC
Idle oscillation rate (max)	14000 OPM

Weight and Dimensions

Weight	1100 g