Makita BO6030 User Manual

6
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Switch action
CAUTION:
• Before plugging in the tool, always check to see that the
switch trigger actuates properly and returns to the “OFF”
position when released.
• Switch can be locked in “ON” position for ease of
operator comfort during extended use. Apply caution
when locking tool in “ON” position and maintain firm
grasp on tool.
To start the tool, simply pull the switch trigger. Release the
switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch trig-
ger fully, then release it.
Speed adjusting dial
The rotating speed can be changed by turning the speed
adjusting dial to a given number setting from 1 to 5.
Higher speed is obtained when the dial is turned in the direc-
tion of number 5. And lower speed is obtained when it is
turned in the direction of number 1.
Refer to the table for the relationship between the number
settings on the dial and the approximate rotating speed.
A range: For polishing
B range: For finish sanding
C range: For regular sanding
1. Lock button
2. Switch trigger
1
2
003732
1. Speed adjusting dial
1
003733
Dial setting
Orbits per minute
4000
10000
A
B
C
12345
003734

Makita BO6030 Specifications

General

Power	310 W
Vibration emission	4 m/s²
Eccentricity	1.6 mm
Idle speed (max)	10000 RPM
Idle speed (min)	4000 RPM
Oscillating orbit diameter	3.2 mm
Power source	AC

Weight and Dimensions

Depth	308 mm
Width	149.2 mm
Height	181 mm
Weight	2300 g
Sanding disc diameter	150 mm