Makita DBO180 User Manual

9 ENGLISH
Removing and reinstalling the skirt
CAUTION: Do not use the tool without the skirt.
Otherwise dust is scattered all over.
You can choose one of 12 directions of the skirt in
accordancewithyourpurpose.
1
2
►1. Skirt 2. Screw
To remove the skirt, remove the screw and remove the
skirtwithslightlyopeningitforbothsides.
1
►1. Skirt
Toreinstalltheskirt,installitwithslightlyopeningitfor
both sides. And fasten the screw.
CAUTION: Do not set the skirt other than
thedesignatedangle.Otherwisethetoolmaybe
damaged.
OPERATION
WARNING: Never switch on the tool when it is
incontactwiththeworkpiece,itmaycauseaninjury
to operator.
Sanding operation
CAUTION:
• Never run the tool without the abrasive disc. You
mayseriouslydamagethepad.
• Neverforcethetool.Excessivepressuremay
decreasethesandingefciency,damagethe
abrasive disc or shorten tool life.
• Using the tool with the pad edge contacting the
workpiecemaydamagethepad.
Holdthetoolrmly.Turnthetoolonandwaituntilit
attainsfullspeed.Thengentlyplacethetoolonthe
workpiecesurface.Keepthepadushwiththework-
pieceandapplyslightpressureonthetool.
CAUTION: The sanding pad rotates clockwise
duringtheloadedoperation,butitmayrotatecounter-
clockwise during the no-load operation.
Polishing operation (optional)
CAUTION:
• UseonlyaMakitagenuinespongepad,feltpad
or wool pad (optional accessories).
• Alwaysoperatethetoolatlowspeedtoprevent
worksurfacesfromheatingabnormally.
• Neverforcethetool.Excessivepressuremay
decreasethepolishingefciencyandcause
motor overload, resulting in tool malfunction.

Makita DBO180 Specifications

General

Depth	175 mm
Width	123 mm
Height	153 mm
Weight	1700 g
Operating time	- min
Battery voltage	18 V
Dust extraction port	Yes
Power source	Battery
Eccentricity	1.4 mm
Idle speed (max)	11000 RPM
Idle speed (min)	7000 RPM
Oscillating orbit diameter	2.8 mm
Uncertainty K	1.5 m/s²
Dust container type	Dust bag

Weight and Dimensions

Sanding disc diameter	125 mm