12 ENGLISH
3. Liftuptheguidebartipslightlyandadjustthe
chaintension.Turnthechainadjustingscrewclockwise
to tighten, turn it counterclockwise to loosen.
Tighten the saw chain until the lower side of the saw
chaintsintheguidebarrailasillustrated.
1
2
3
►1. Guide bar 2. Saw chain 3.Chainadjustingscrew
4. Keep holding the guide bar lightly and tighten the
retaining nuts to secure the sprocket cover.
1
►1. Retaining nut
Make sure that the saw chain does not loose at the
lowersideandthesawchaintssnuglyagainstthe
lower side of the bar.
OPERATION
Lubrication
Saw chain is automatically lubricated when the tool is in
operation. Check the amount of remaining oil in the oil
tank periodically.
Torellthetank,laythechainsawonitssideand
remove the oil tank cap. The proper amount of oil is 200
ml.Afterrellingthetank,makesurethattheoiltank
cap is tightened securely.
1
2
►1. Oil tank cap 2. Oil tank (translucent)
Afterrelling,holdthechainsawawayfromthe
tree. Start it and wait until lubrication on saw chain is
adequate.
NOTICE: When lling the chain oil for the rst
time, or relling the tank after it has been com-
pletely emptied, add oil up to the bottom edge of
the ller neck. The oil delivery may otherwise be
impaired.
NOTICE: Use the saw chain oil exclusively for
Makita chain saws or equivalent oil available in
the market.
NOTICE: Never use oil including dust and parti-
cles or volatile oil.
NOTICE: When pruning trees, use botanical oil.
Mineral oil may harm trees.
NOTICE: Before the cutting operation, make sure
that the provided oil tank cap is screwed in place.