Spare parts
Reliable long-term operation. as well as the safety of your chain saw, depend among other things
on
the quality of the spare parts
used. Use only original MAKITA parts, marked
Only original spare parts and accessories guarantee the highest quality in material, dimensions, function and safety.
Original spare parts and accessories can be obtained from your local dealer. He will also have the spare part lists
to
determine the
required spare part numbers, and will be constantly informed about the latest improvements and spare part innovations.
Please bear in mind that
if
parts other than original MAKITA spare parts are used, this will automatically invalidate the MAKITA
product guarantee.
A
./MA
Observation
Engine
runs
Guarantee
MAKITA guarantees the highest quality and will therefore reimburse all costs for repair by replacement of damaged parts resulting
from material or production faults occurring within the guarantee period after purchase. Please note that in some countries particular
guarantee conditions may exist.
If
you have any questions, please contact your salesman, who is responsible for the guarantee
of
the product.
Please note that we cannot accept any responsibility for damage caused by:
incorrect carburetor adjustment.
Normal wear and tear.
bbvious overloading due to permanent exceeding of the upper performance limits.
Use of guide bars and chains which have not been approved.
Use of guide bar and chain lengths which have not been approved.
Use of force, improper use, misuse or accidents.
Damage from overheating due to dirt
on
the fan housing.
Work on the chain saw by unskilled persons or inappropriate repairs.
Use of unsuitable spare partsor parts which are not original MAKITA parts, insofar as they have caused the damage.
Use of unsuitable or old oil.
Damage related
to
conditions arising from lease
or
rent contracts.
Cleaning, servicing and adjustment work is not covered by the guarantee. All repairs covered by the guarantee must be performed
by a MAKITA service center.
Disregard of the instruction manual.
Non-performance of the required maintenance and cleaning.
Cause
Chain brake actuated.
Troubleshooting
I
Malfunction
-
Ignition spark
No ignition spark
Fuel tank
is
tilled
Inside
Outside
Starter
does
not engage
Fuel tank is
filled
Ignition spark
Fuel tank is filled
1
Chaindoesnotrun
Malfunction in fuel
supply
system, cm-
pression system, mechanical malfunction.
Switch on STOP, fault or short-circuit in
the
wiring, plug cap or
spa&
plug defective.
Choke in wrong
position,
carburetor defective,
suction head dirty. fuel line bent or intermpted.
Cylinder base packing ring defective, radial
shaft packings defective. cylinder or piston rings
defective
Spark plug does not seal.
Spring in starter broken, broken parts
inside the engine.
'
Wrong carburetor adjustment.
Wrong idling adjustment, suction head or
cahuretor dirty. Tank venting defective. fuel line
intermpted. cable defective. STOP switch
defhe. Starting vaive dirty (DCS
431).
Warm start difficulties
I
No oil on the chain
Engine
starts,
but
dies immediately
Oil tank empty.
Oil guide groove dirty.
Oilpump adjusting screw incorrectly adjusted.
No chain lubrication
30
System
Chain brake
Ignition system
Fuel supply
Compression
system
Mechanical
malfunction
Carburetor
Fuel supply
Several systems
may be involved
simultaneously
Oil tanWpump
Engine
is
idling
Air filter or prefilter dirty, wrong carburetor adjust
ment. muffler clogged, exhaust channel in cylin-
der clogged, spark arrester screen clogged.
To Next Page
Loading...
Need help?
General
