Makita DF333DNX12 User Manual

6 ENGLISH
Vibration
The vibration total value (tri-axial
vector sum) determined according to
EN62841-2-1:
Model DF333D
Work mode: drilling into metal
Vibration emission (a
h,D
) : 2.5
m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
Model DF033D
Work mode: drilling into metal
Vibration emission (a
h,D
) : 2.5
m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
NOTE: The declared vibration
emission value has been
measured in accordance
with the standard test
method and may be
used for comparing one
tool with another.
NOTE: The declared vibration
emission value may also
be used in a
preliminary assessment of
exposure.
WARNING: The vibration
emission during actual use of
the power tool can differ from the declared emission
value depending on the
ways in which the
tool is used.
WARNING: Be sure to
identify safety measures to
protect the operator that
are based on an
estimation of exposure in the actual
conditions of use (taking account of all
parts of the
operating cycle such as
the times when the tool is switched off
and when it is running idle in addition to the trigger
time).
EC Declaration of Conformity
For European countries only
The EC declaration of
conformity is included as Annex
A to this instruction manual.
SAFETY WARNINGS
General power tool safety warnings
WARNING: Read all safety warnings,
instructions, illustrations and specifications
provided with this power tool. Failure to
follow all instructions listed
below may result in
electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in
the warnings refers to your
mains-operated (corded) power tool
or battery-operated (cordless) power
tool.
Cordless driver drill safety
warnings
1. Use auxiliary handle(s), if supplied with the
tool. Loss of control can
cause personal injury.
2. Hold power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory may contact
hidden wiring. Cutting accessory
contacting a "live" wire
may make exposed metal
parts of the power
tool "live" and could give the operator an
electric shock.
3. Hold power tool by insulated gripping
surfaces, when performing an operation
where the fastener may contact hidden wiring.
Fasteners contacting a "live"
wire may make exposed
metal parts of the power tool "live" and could give
the operator an electric shock.
4. Always be sure you have a firm footing. Be
sure no one is below when using the tool in
high locations.
5. Hold the tool firmly.
6. Keep hands away from rotating parts.
7. Do not leave the tool running. Operate the
tool only when hand-held.
8. Do not touch the drill bit or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
9. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
10. If the drill bit cannot be loosened even you
open the jaws, use pliers to pull it out. In such
a case, pulling out the
drill bit by hand
may result in injury
by its sharp edge.
SAVE THESE INSTRUCTIONS.

Makita DF333DNX12 Specifications

General

Brand	Makita
Model	DF333DNX12
Category	Drill
Language	English