CAUTION: Before installing the battery
cartridge into the tool, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the tool, simply
pull the switch trigger. Tool
speed is increased by
increasing pressure on the switch
trigger. Release the switch trigger to stop.
Lighting up the front lamp
► Fig.4: 1. Lamp
CAUTION: Do not look in the light or see the
source of light directly.
Pull the switch trigger to
light up the lamp. The
lamp keeps on lighting while
the switch trigger is being
pulled. The lamp goes out
approximately 10 seconds after
releasing the switch trigger.
NOTE: Use a dry cloth
to wipe the dirt
off the lens of
the lamp. Be careful not to scratch the
lens of lamp, or it may lower the
illumination.
Reversing switch action
► Fig.5: 1. Reversing switch lever
CAUTION: Always check the direction of
rotation before operation.
CAUTION: Use the reversing switch only
after the tool comes to a complete stop. Changing
the direction of rotation before
the tool stops may
damage the tool.
CAUTION: When not operating the tool,
always set the reversing switch lever to the
neutral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation
or from the B side
for counterclockwise rotation.
When the reversing switch lever is in the neutral
position, the switch trigger cannot
be pulled.
Speed change
► Fig.6: 1. Speed change lever
Position of
speed
change
lever
To Next Page
Loading...
Need help?
General
