Makita DHP482 Technical Information

P 8/ 11
ASSEMBLING
3. Speed change lever
ASSEMBLING
4. Leaf spring
ASSEMBLING
3－2
Projection of
Speed change lever
Pin on the lever of
Speed change lever
Gear ass’y
Speed change lever ass’y
2. Push Compression spring 4 with
projection of Speed change lever.
3. Fit Pin on the lever of Speed
change lever into Compression
spring 4 while pushing Speed
change lever ass’y in the direction
of this arrow.
4. Shift Speed change lever in the either direction.
Pin on the lever of
Speed change lever
Projection of
Speed change lever
4
－
1
Housing L
Leaf spring
1. Assemble Leaf spring as shown below.
Face projection inside.
3－1
1. Assemble Compression spring 4 (x2) as drawn.
Compression spring 4(x2)
Hook one roll of the spring to
the notches of Speed change
lever.
Makita Corporation

Makita DHP482 Specifications

General

Voltage	18V
No Load Speed (High)	0-1, 900 RPM
No Load Speed (Low)	0-600 RPM
Chuck Capacity	13mm
Max. Drilling Capacity in Steel	13mm
Max. Drilling Capacity in Wood	38mm
Max. Drilling Capacity in Masonry	13mm
Max Torque (Soft)	36Nm
Battery Type	Li-ion
Length	198mm
Blows per Minute (High)	0-28, 500 BPM
Blows per Minute (Low)	0 - 9, 000 IPM
Weight	1.5 - 1.8 kg