Makita DLM382 User Manual

6 ENGLISH
2. Placeyourhandsinthemiddleofthebattery
cover and push it.
3. Beforetherstoperation,checkthatthepivot
pointofthebatterycoverisattachedproperly.Ifthe
batterycoverisinstalledcorrectly,itwillnotopenuntil
thebatterycoverlockingleverispulled.
1
2
►1. Pivot point 2.Batterycoverlockinglever
Installing the handle
NOTICE: When installing handles, position the
cords so that they are not caught by anything
between the handles. If the cord is damaged, the
mower switch may not work.
1. Slide the both ends of lower handle into the
groovesofthemowerthenfullytightentheclamping
screws.
1
2
►1. Clamping screw 2. Lower handle
2. Align the screw holes of upper handle and lower
handle. Secure them with the clamping screws and
nuts.
2
2
1
►1. Clamping nut 2. Clamping screw
NOTE:Holdtheupperhandlermlysothatitdoes
notdropoffyourhand.
3. Attach the holders to the handle. Position the
powersupplycordasshowninthegure.
1
►1. Holder
Removing the mulching plug
Optional accessory
1. Open the rear cover.
1
►1. Rear cover

Makita DLM382 Specifications

General

Power Source	Battery
Voltage	18 V
Cutting Width	38 cm
Cutting Height	20-75 mm
Grass Box Capacity	40 L
Battery Type	Lithium-ion
Cutting Height Adjustment	Central