Makita DLM382 - Functional Description and Protection Systems; Installing or Removing Battery Cartridge; Machine;Battery Protection System Overview

8 ENGLISH
FUNCTIONAL
DESCRIPTION
Installing or removing battery
cartridge
CAUTION: Always switch off the machine
before installing or removing of the battery
cartridge.
CAUTION: Make sure that you lock the battery
cover before use. Otherwise,mud,dirt,orwatermay
causedamagetotheproductorthebatterycartridge.
CAUTION: Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
itmayaccidentallyfalloutofthemachine,causing
injurytoyouorsomeonearoundyou.
CAUTION: Do not install the battery cartridge
forcibly.Ifthecartridgedoesnotslideineasily,itis
notbeinginsertedcorrectly.
NOTE:Themachinedoesnotworkwithonlyone
batterycartridge.
To install the battery cartridge;
1. Slidethebatterycoverlockingleverandopenthe
batterycover.
1
2
►1.Batterycover2.Batterycoverlockinglever
2. Alignthetongueonthebatterycartridgewiththe
slot on the mower then slide the cartridge until it locks in
place with a little click.
1
►1.Batterycartridge
3. Insertthelockkeyintheplaceshowninthegure
as far as it will go.
1
►1.Lockkey
4. Closethebatterycoverandpushituntilitis
latched with the locking lever.
To remove the battery cartridge from the mower;
1. Slidethebatterycoverlockingleverandopenthe
batterycover.
2. Pulloutthebatterycartridgefromthemowerwhile
sliding the button on the front of the cartridge.
3. Pulloutthelockkey.
4. Closethebatterycover.
Machine / battery protection system
Themachineisequippedwithamachine/battery
protectionsystem.Thissystemautomaticallycutsoff
powertothemotortoextendtoolandbatterylife.The
machinewillautomaticallystopduringoperationifthe
machineorbatteryisplacedunderoneofthefollowing
conditions.
Overload protection
When the machine is operated in a manner that causes
ittodrawanabnormallyhighcurrent,themachine
automaticallystopswithoutanyindication.Inthissitu-
ation, turn the machine off and stop the application that
caused the machine to become overloaded. Then turn
the machine on to restart.
Overheat protection
When the machine is overheated, the machine stops
automatically.Letthemachinecooldownbeforeturning
the machine on again.
Overdischarge protection
Whenthebatterycapacitybecomeslow,themachine
stopsautomatically.Iftheproductdoesnotoperate
even when the switches are operated, remove the bat-
teries from the machine and charge the batteries.