8 ENGLISH
1
2
3
1
2
3
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Installing or removing the mandrel container
NOTICE:
Be sure to install the mandrel container to the
tool before operating the tool. If the mandrel container is
not installed to the tool, the tool will not operate.
To remove the mandrel container, rotate it counter clock-
wise. To install the mandrel container, rotate it clockwise.
1
► 1. Mandrel container
OPERATION
CAUTION: Keep your hand or face away from
the front part of the tool. The rivet or broken off
mandrel may accidentally ejected, and you may be
injured.
Installing a blind rivet
CAUTION: Before the mandrel container
becomes full, empty it regularly by removing the
mandrel container. Otherwise, the tool may be dam-
aged, and the damaged parts may cause an injury.
CAUTION: When inserting a blind rivet into
the nose piece, be sure to switch off the tool.
Otherwise, you may be injured with the tool tip.
CAUTION: Do not the leave a blind rivet in the
nose piece. If the tool is switched on accidentally, the
blind rivet is ejected and may cause an injury.
NOTICE: After installing a blind rivet, be sure
to eject the broken off mandrel into the mandrel
container by tilting the tool backward before
installing next blind rivet. If the end of the broken
off mandrel sticks out from the nose piece, switch
off the tool and remove the mandrel. Otherwise,
the broken off mandrels may become clogged and
cause a malfunction of the tool.
1. Insert the blind rivet into the nose piece.
1
2
► 1. Blind rivet 2. Nose piece
2. Press the tool tip against the workpiece, and then
pull the switch trigger. After the mandrel is broken off,
release the switch trigger.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
