Makita DUR184L User Manual

11 ENGLISH
Toreducetheriskdamagingtheobjectsinfrontofthe
cutting head, insert the wire guard so that it controls the
cutting range of the mowing line.
Slightlyexpandthewireguardoutwardandtheninsert
it into the holes of the protector.
1
►1.Wireguard
NOTE:Donotexpandthewireguardoutwardtoo
much. Otherwise it may break.
Whenwireguardisnotinuse,liftitfortheidleposition.
Installing nylon cutting head
Optional accessory
CAUTION: If the nylon cutting head acciden-
tally impacts a rock or hard object during oper-
ation, stop the tool and inspect for any damage.
If the nylon cutting head is damaged, replace it
immediately. Use of a damaged cutting tool could
resultinseriouspersonalinjury.
CAUTION: Make sure to remove the hex
wrench after installation.
NOTICE: Be sure to use genuine Makita nylon
cutting head.
1. Turn the tool upside down so that you can replace
the cutting tool easily.
2. Insertthehexwrenchthroughtheholeonthe
motor housing and rotate the receive washer until it is
lockedwiththehexwrench.
3. Place the nylon cutting head onto the threaded
spindle directly and tighten it by turning it clockwise.
4. Removethehexwrench.
To remove the nylon cutting head, turn it counterclock-
wisewhileholdingthereceivewasherwiththehex
wrench.
1
2
3
4
►1. Nylon cutting head 2. Metal guard 3. Receive
washer 4.Hexwrench
OPERATION
Correct handling of tool
WARNING: Always position the tool on your
right-hand side. Correct positioning of the tool allows
formaximumcontrolandwillreducetheriskofseri-
ouspersonalinjurycausedbykickback.
WARNING: Be extremely careful to maintain
control of the tool at all times. Do not allow the
tool to be deected toward you or anyone in the
work vicinity.Failuretokeepcontrolofthetool
couldresultinseriousinjurytothebystanderandthe
operator.

Makita DUR184L Specifications

General

Brand	Makita
Model	DUR184L
Category	Trimmer
Language	English