star ter
Unscrew three screws (1
Remove fan housing (2
Remove the air guide (3
spring (13
14
Carefully let the drum turn until the return spring is no longer
Unscrew screw (7) and remove the driver () and spring
(6)
(10
Pull knot (115
Pull knot (12) into the starter grip (
Put the drum on its spindle and turn it slightly until the return
Place the spring (6) in the driver () and place them together
in the drum (5) while turning slightly
Insert screw (7) and
Guide the into the slot (14) on the drum and turn
the drum with the clockwise three
Repeat the procedure The starter grip should now
stand straight up on the fan
entire surface of the hollow side, and
the fan housing
the return spring pack (13), which should now have fallen out,
to relax in a controlled manner if the return spring has popped
Carefully insert a new return spring cassette and press
down until it
Place the drum on it and turn it slightly until the return
spring
Install the spring (6) and driver () and screw on tight with
screw (7)
starter
If the spring (6) in the system
is more will to start the engine
and you will notice some resistance when pulling the starter
If you notice this, check the spring (6)
and replace if
Insert the air guide (3) in the fan housing so that the three
recesses (4
Position the fan housing against the housing, press against it
Tighten screws (1
To Next Page
Loading...
Need help?
General
