EasyManuals Logo
Home>Makita>Cutter>EK7650H

Makita EK7650H User Manual

Makita EK7650H
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
26
Storage
WARNING:
When draining out fuel, always stop the engine, let it cool, and then drain fuel.
Draining fuel directly after stopping the engine may cause ames or re, which could cause burn injuries.
CAUTION:
If the Power Cutter is not to be used for a prolonged period, drain out all the fuel, and store the Power Cutter in a dry, clean location.
Use the following procedures to drain out fuel from fuel tank and carburetor.
(1) Remove fuel tank cap, drain out fuel until tank is empty.
At this time, check to see if there is foreign matter inside the fuel tank. If there is, remove.
(2) Use a piece of wire, etc., to pull out fuel lter from neck of tank.
(3) Press the primer pump until all of the fuel is forced back into the fuel tank, and then be sure to clean out this fuel from the fuel tank.
(4) Return the fuel lter to its position in the fuel tank, and then rmly retighten fuel tank cap.
(5) Finally, run the engine until it stops.
(6) Remove the spark plug, and drain out the few drops of engine oil from the socket hole.
(7) Slowly pull the starter handle, to circulate oil throughout the engine, and then remount the spark plug.
(8) Place the drained off fuel in a proper fuel container, and store in a shaded place that is well ventilated.

Table of Contents

Other manuals for Makita EK7650H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Makita EK7650H and is the answer not in the manual?

Makita EK7650H Specifications

General IconGeneral
BrandMakita
ModelEK7650H
CategoryCutter
LanguageEnglish

Related product manuals